Specify Duration for Each File

SmartSignage switches content according to the time set in “Settings” > “Behavior” > “Duration for each content”.
You can specify the duration for each file since Ver.2.8. The duration is specified according to a specific format.
For filenames that do not match the format, the duration set in “Settings” is used.

To use this function, enable “Settings” > “Behavior” > “Duration for each content” > “Using values embedded in the file name”. If it is invalid, the value in filename is ignored.

File Name Format

To specify the duration for each file, add @t after the normal file name without the extension, then specify the number of seconds, and finally add the extension.
The format is:

<any name>@t<seconds|milliseconds>[ms].<extension>

<> is required. [] can be omitted.

Specify the display duration in seconds. A decimal point cannot be specified. When setting a value less than 1 second, specify it in milliseconds (11000 second) and add ms.
For example, if you want 5.5 seconds, specify 5500ms.

Special Value

Negative values have specific functions.

  • -2
    For video files, the video will play to the end. For other files, it will be the duration set in “Settings” > “Behavior” > “Duration for each content”.

  • -1 , 0, or a negative value exept -2
    The duration set in “Behavior” > “Duration for each content” is applied. If “Settings” > “Behavior” > “Duration for each content” > “Video playback use its own duration” is enabled, the video file will be played to the end.

Examples

  1. In the case of an image file image.png  

    • To display for 6 seconds
      image@t6.png
    • To display for 8.5 seconds
      image@t8500ms.png
    • To used the duration set in the settings
      image@t-1.png
  2. In the case of a video file video.mp4  

    • To play for 15 seconds
      video@t10.mp4
    • To play for 10.8 seconds
      video@t1800ms.mp4
    • To play to the end
      video@t-2.mp4
    • To used values set in the settings
      video@t-1.mp4